– Pre Programmed with 10 selectable Power settings via X10 Switch
– Instant Plug in Performance (replaces standard CDI with no mods to wiring required
– Handlebar Switch for Dynamic Map Selection
– Rubber Mounting Boot + Brackets supplied (where required)
– V-Boost – Internal Voltage Boost Circuit for maximising Spark Energy across the entire rev range
– Power Jet Control – Multiple On / Off (where applicable)
– Rev Limiter (where required)
– Small form factor for ease of mounting
– Race Proven Reliability
All Vortex CDIs are factory programmed with Performance Maps developed through dyno and track testing exclusively with our network of technical support centres and top race teams worldwide.
NOTE: The X10 CDI comes with a Handlebar Switch included.
•Pre Programmed with 10 Performance Fuel & Ignition maps – all the work is done for you!
•Instant Plug in Performance (replaces standard ECU with no mods to wiring required)
•Fuel Trim Switches adjust fuel mapping by +12.5% to -10% in Lo , Mid and Hi throttle bands
•Adjustments require only a screwdriver and integrated switches provide visual feedback.
•Simple to install with mounting hardware supplied (where required)
•V-Boost – Programmable Voltage Boost Circuit for maximising Spark Energy across the entire rev range
•Higher / Lower Rev Limit (where required)
•Robust design is fully encapsulated and O-ring sealed
•Diagnostic Flash codes – tests for sensor faults and flashes codes to OEM FI light
•Race Proven reliability
•Re Programmable (Software and Interface hardware not Included)
All Vortex products are Tomasin Racing factory programmed with Performance Fuel and Ignition Maps developed through extensive dyno and track testing by Tomasin R&D engineers with our network of race teams worldwide.